top

View previous topic Set labels on Element LCD buttons without PathFinder? View next topic

Post new topic Reply to topic Axia Discussion Board Forum Index | Element Consoles    Page 1 of 1

Tue Nov 12, 2013 12:22 am
PostPost subject: Set labels on Element LCD buttons without PathFinder? Reply with quote
wharrison



Joined: 13 Jun 2013
Posts: 6
Location: Virginia

Is there a way to set the text displayed on a LCD button panel in an Element console that does not require the use of Pathfinder? I'm using the button panel in snake mode with GPIO nodes located elsewhere. It currently just says "snake," the Axia channel number, and the pin number of that port.
Back to top View user's profile Send private message
 
Thu Nov 21, 2013 1:06 am
PostPost subject: Reply with quote
AXIA_milos
Axia Team


Joined: 25 May 2007
Posts: 279
Location: San Luis Obispo, CA

That is a good question and one I've not come across. At the moment there is no means to change the txt when in GPIO snake mode. I believe that in this mode the displays are hard coded to represent their configuration state which is that they are in snake mode, what channel assignment, and which pin they are tied to.
Back to top View user's profile Send private message Send e-mail
 
Thu Nov 21, 2013 1:57 am
PostPost subject: Reply with quote
wharrison



Joined: 13 Jun 2013
Posts: 6
Location: Virginia

You are correct; that is indeed what they display.
Back to top View user's profile Send private message
 
Post new topic Reply to topic Axia Discussion Board Forum Index | Element Consoles    Page 1 of 1
Display posts from previous:   
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum