Post subject: VMIX inputs on/off based on a GPIO trigger
Joined: 18 Aug 2014
Location: Manchester, UK
From the iQ manual, regarding VMIX function:
At the top is the V-Mix Master field. This gives the option to assign a Livewire GPIO channel for control of the VMixer. This channel number also gets assigned to a GPIO port, allowing you to have ON/OFF control of
VMix channels through GPIO.
So it appears that if I was to assign a Livewire channel number in the VMIX settings page, and then in the GPIO config page link this Livewire channel to a physical GPIO port on the engine. I would then be able to turn VMIX channels 'on' or 'off' via a GPI input?
In the manual is a table of pin outs for the various GPIO modes, but there isn't details listed for VMIX control. I'd guess that pins 11 through 15 turn on VMIX inputs 1 through 5?
Could you share some details on VMIX GPIO control.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum