I have two problems setting up the Pathfinder Audio Based Events Backup Route:
1. The Route does not restore to Primary once the Primary source is restarted. The only way I can restore the Primary source is to do a manual switch in Pathfinder PC.
2. The Backup source I want to use originates from a PC using Axia Audio Drivers. On failure of the Primary source I see the "F" fail symbol in Pathfinder PC but the Backup source will not automatically switch to the destination. I am able to manually switch to the Backup source using Pathfinder PC and then see the "B" Backup symbol in Pathfiner PC. It seems that the sensing does not recognise the backup source as being valid, so will not switch.
Joined: 25 May 2007
Location: Cleveland OH
You did not state the current version of Pathfinder Server or the IP Driver version.
[quote] 1. The Route does not restore to Primary once the Primary source is restarted. The only way I can restore the Primary source is to do a manual switch in Pathfinder PC. [/quote]
This is by design. The standard silence detect feature does not auto-routeback, because it is assumed audio may get restored briefly during the repair process, and we want an engineer to actually confirm that everything is ok and manually make the switch back.
If you want it to auto-switchback, this can be accomplished by using the standard silence event but adding a STACK event with 2 qualifiers and an action to force the switchback to primary. Qualifier 1 verifies the destination is currently routed to the backup. Qualifier 2 would be audio present sensor on the primary for a given amount of time. Action would of course be the route back to primary.
[quote]2. The Backup source I want to use originates from a PC using Axia Audio Drivers. On failure of the Primary source I see the "F" fail symbol in Pathfinder PC but the Backup source will not automatically switch to the destination.[/quote]
The metering and audio detection on the Axia driver is NOT supported in the current release of driver, ver 220.127.116.11. The route to backup will only happen if PFS sees there is audio present on the backup.
To bypass this issue you can either route the PC source to a Node Output and loop it back to a node input. Then use the node source as the backup route.
The other option: rather than using the Single event Backup Route option create a STACK event that does the backup route from the Primary Route at the loss of audio. Doing it this way then forces the route change to the PC source regardless if there is audio present or not on the PC source. Then you have the second stack event you created for the auto switchback when audio becomes present on the Primary route to switch it back.
Note that this audio and metering sensing has been added in a soon to be released driver version. This would then allow PF to sense audio presence on PC Driver sources. Please check the Axia website within the next week for more information, www.axiaaudio.com . Also check to be sure you have the latest Pathfinder SW. Go to www.softwareauthority.com/axia for the latest and greatest.
If you have more direct questions please contact Axia support directly via email or by phone.
_________________ John M.
Axia Support Engineer
I have Pathfiner setup using two stack events to switch from a Primary Audio Route to a secondary source upon 30 seconds of silence and then return back to primary once program has returned to normal for at least 5 seconds.
My question is, how can I have Pathfinder send an notification email when program has returned back to normal? Currently if send email is setup in the second stack event upon primary audio detect it will constantly be sending emails. Ideally it would be great if Pathfinder could send a notifiaction email after a silence and return to normal has occured.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum