top

View previous topic Profanity Delay control View next topic

Post new topic This topic is locked: you cannot edit posts or make replies. Axia Discussion Board Forum Index | Tech Tips    Page 1 of 1

Wed Aug 11, 2010 1:19 am
PostPost subject: Profanity Delay control Reply with quote
AXIA_milos
Axia Team


Joined: 25 May 2007
Posts: 279
Location: San Luis Obispo, CA

The standard Element control/navigation modules has 4 "Profanity Delay" buttons. These are designed to be *mapped* to a GPIO port. In order to do this, follow these simple steps.
(1) From each Show Profile configuration page, you will select the monitor section link.
(2) The following page there will be a GPIO channel assignment for Profanity delay field. In the text box you are to place a unique channel number. Save the changes.
(3) Now on the GPIO port that connects to your Profanity Delay, assign the same channel number in the text box (HTML configuration for GPIO enabled device). Save changes.
(4) Go to the Element surface and load the show profile that you just made changes to. The buttons should trigger based on the table that is in GPIO Chapter of the Element manual.

Back to top View user's profile Send private message Send e-mail
 
Post new topic This topic is locked: you cannot edit posts or make replies. Axia Discussion Board Forum Index | Tech Tips    Page 1 of 1
Display posts from previous:   
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum