top

View previous topic How to: Silence detected route change View next topic

Post new topic Reply to topic Axia Discussion Board Forum Index | PathfinderPC and PathfinderPRO    Page 1 of 1

Tue Sep 28, 2010 1:10 pm
PostPost subject: How to: Silence detected route change Reply with quote
Richard Fulton



Joined: 03 Sep 2007
Posts: 5

There are many ways of doing this but I will share what we have found as the easiest.

What we need is to detect silence to the processor. This MUST be for both studios. We change between studios by clicking a button, then studio 2 goes live to the Processor.

So in Axia Element we have setup a VMIX with 1 input to the VMIX. This is PGM1 from Onair 1.

Then in Pathfinder we set up Pathfinder Mini with a switch to switch PGM1 from Onair 1 to PGM1 from Onair 2. This is done to the input of the VMIX.

Then in Pathfinder we go to Stacked Events. We setup the Qualifier as Audio Level State Silence Detect for 15 seconds. The source is the VMIX. Then it does not care what source is coming into the VMIX, all it cares about is if there is silence.

Then we get it to switch, turn on CD players, send email etc. And the opposite if the audio is restored.

Hope this helps anyone out.....

Back to top View user's profile Send private message Send e-mail
 
Thu Sep 30, 2010 9:12 pm
PostPost subject: Reply with quote
clarknovak



Joined: 25 May 2007
Posts: 163
Location: San Diego, CA

Great tip, Richard; thanks for sharing it. I've made it a sticky so others can find it easily!

_________________
Clark Novak
Marketing Director
Telos Alliance
Back to top View user's profile Send private message Visit poster's website
 
Post new topic Reply to topic Axia Discussion Board Forum Index | PathfinderPC and PathfinderPRO    Page 1 of 1
Display posts from previous:   
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum