top

View previous topic iQ GPIO View next topic

Post new topic Reply to topic Axia Discussion Board Forum Index | iQ & Radius Consoles    Page 1 of 1

Wed Jul 13, 2011 10:08 pm
PostPost subject: iQ GPIO Reply with quote
geko



Joined: 13 Jul 2011
Posts: 10

Hello,
this might seem like a very basic or naive question, but we are wondering on how to make use of the GPIO Signals that the iQ console sends to the PC (for playout system faderstarts etc.) ? I trust that these signals are sent over the Network/Audio cable that connects the Axia Core and the Playout PC?
Thanks for your help,
Georges

Back to top View user's profile Send private message
 
Fri Jul 15, 2011 10:57 pm
PostPost subject: Reply with quote
AXIA_milos
Axia Team


Joined: 25 May 2007
Posts: 279
Location: San Luis Obispo, CA

If the PC has the multichannel version of IP driver, yes, the GPIO is carried through IP.
Back to top View user's profile Send private message Send e-mail
 
Sat Jul 16, 2011 1:16 am
PostPost subject: Reply with quote
geko



Joined: 13 Jul 2011
Posts: 10

OK good to know.
So then - the physical GPIO port on the back of the Core is disabled whenever that GPIO signal is carried over IP?
How can I test if the signal from the Core is received by the PC? I'm able to telnet into the core and check the GPI/O status, but I don't know how to make sure that my Playout PC sees the GPO signal. I did check the GPIO Control Surface Bridge Checkbox...
Thanks very much,
Georges

Back to top View user's profile Send private message
 
Sat Jul 16, 2011 2:03 am
PostPost subject: Reply with quote
AXIA_milos
Axia Team


Joined: 25 May 2007
Posts: 279
Location: San Luis Obispo, CA

Telnet to the IP driver, port 93. If using the same PC that ip driver is installed, you can use the loopback address.

telnet 127.0.0.1 93

Enter in the command for reporting GPO, all caps.

ADD GPO

You should get a response of the current GPO states. Press the ON/OFF buttons for the source, this should show changes in GPO state.

Back to top View user's profile Send private message Send e-mail
 
Post new topic Reply to topic Axia Discussion Board Forum Index | iQ & Radius Consoles    Page 1 of 1
Display posts from previous:   
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum