this might seem like a very basic or naive question, but we are wondering on how to make use of the GPIO Signals that the iQ console sends to the PC (for playout system faderstarts etc.) ? I trust that these signals are sent over the Network/Audio cable that connects the Axia Core and the Playout PC?
Thanks for your help,
OK good to know.
So then - the physical GPIO port on the back of the Core is disabled whenever that GPIO signal is carried over IP?
How can I test if the signal from the Core is received by the PC? I'm able to telnet into the core and check the GPI/O status, but I don't know how to make sure that my Playout PC sees the GPO signal. I did check the GPIO Control Surface Bridge Checkbox...
Thanks very much,
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum