We have all our VMixes spread for each station on various Elements. Then the Automation system talks to PathFinder Pro via the ACU Emulation. All is happy until you have to reboot an Element or Audio server.
Our node that feeds our on-air is setup to listen to the mix for each station. What I need to do is switch the feed to the node from the Vmix to the direct source. Re-routing the direct source while I reboot either the Element serving the on-air node or the audio server in-between a need to switch sources.
Would this be done via a Stack Event or could a Panel be built that I can just say for now take the direct source instead of the Vmix while I work with the reboot?
Joined: 25 May 2007
Location: San Luis Obispo, CA
You could do either. (or both)
Build a panel that upon a button press causes an action to take place. For example a button panel with a button for each of your vmix inputs. Pressing a button would cause a route change. You could incorporate stack events in this so that the button would be yellow to show that vmix input is ON, and gray for OFF. This way you could see which source was active ON AIR. By pressing the button the stack event would route that source to the destination. The stack event could then make the button show green indicating a route of that source instead of the vmix output.
You could also just use stack events without a button interface, but then you would need a trigger that is the qualifier to make the route change occur.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum