top

View previous topic IQ Phone Profile View next topic

Post new topic Reply to topic Axia Discussion Board Forum Index | iQ & Radius Consoles    Page 1 of 1

Thu Jul 10, 2014 4:21 am
PostPost subject: IQ Phone Profile Reply with quote
rgsilakau



Joined: 28 Jun 2014
Posts: 2
Location: Papua New Guinea

Hi

I have installed a HX1 but I can't seem to get the GPIO on QOR32 engine to work. I have created a Phone source type for the HX1 and have assigned the GPIO accordingly but I don't seem to get the pulse on pins 4 & 5 to trigger the take and drop function on the HX1. However when I set the phone as Line source, I get the pulse and the HX1 responds correctly. Please help!

Back to top View user's profile Send private message Visit poster's website
 
Wed Jul 16, 2014 10:57 am
PostPost subject: Poor Documentation Reply with quote
rgsilakau



Joined: 28 Jun 2014
Posts: 2
Location: Papua New Guinea

After Days of struggle it was poor manual documentation for OQR Version2.

GPIO control of phone sources which are NOT connected to a Telos hybrid via IP have a slight change to the GPIO template between QOR v1 and QOR v2 software. The function of answer/drop is via the soft key, not the ON/OFF keys. This allows for off-air use of the hybrid.

Back to top View user's profile Send private message Visit poster's website
 
Post new topic Reply to topic Axia Discussion Board Forum Index | iQ & Radius Consoles    Page 1 of 1
Display posts from previous:   
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum